Monday, February 11, 2013

OSU team demonstrates Coal-Direct Chemical Looping for more efficient and low carbon coal heat release

An Ohio State University team has demonstrated the successful operation of Coal-Direct Chemical Looping (CDCL)-which chemically harnesses coal's energy and efficiently contains the carbon dioxide produced before it can be released into the atmosphere. The technology is now ready for testing at a larger scale.

For 203 continuous hours, an OSU combustion unit produced heat from coal while capturing 99% of the carbon dioxide produced in the reaction.

In the simplest sense, combustion is a chemical reaction that consumes oxygen and produces heat. Unfortunately, it also produces carbon dioxide, which is difficult to capture and bad for the environment. So we found a way to release the heat without burning. We carefully control the chemical reaction so that the coal never burns-it is consumed chemically, and the carbon dioxide is entirely contained inside the reactor.

-Liang-Shih Fan, professor of chemical and biomolecular engineering and director of Ohio State's Clean Coal Research Laboratory

The technology uses tiny metal beads to carry oxygen to the fuel to spur the chemical reaction. For CDCL, the fuel is coal that's been ground into a powder, and the metal beads are made of iron oxide composites. The coal particles are about 100 micrometers across and the iron beads are larger, about 1.5-2 millimeters across.

The coal and iron oxide are heated to high temperatures, where the materials react with each other. Carbon from the coal binds with the oxygen from the iron oxide and creates carbon dioxide, which rises into a chamber where it is captured. Hot iron and coal ash are left behind. Because the iron beads are so much bigger than the coal ash, they are easily separated out of the ash, and delivered to a chamber where the heat energy would normally be harnessed for electricity. The coal ash is removed from the system.

The carbon dioxide is separated and can be recycled or sequestered for storage. The iron beads are exposed to air inside the reactor, so that they become re-oxidized be used again. The beads can be re-used almost indefinitely, or recycled.

Since the process captures nearly all the carbon dioxide, it exceeds the goals that DOE has set: new technologies that use fossil fuels should not raise the cost of electricity more than 35%, while still capturing more than 90% of the resulting carbon dioxide. Based on the current tests with the research-scale plants, Fan and his team believe that they can meet or exceed that requirement.

Though other laboratories around the world are trying to develop similar technology to directly convert coal to electricity, Fan's lab is unique in the way it processes fossil fuels. The Ohio State group typically studies coal in the two forms that are already commonly available to the power industry: crushed coal "feedstock," and coal-derived syngas.

The latter fuel has been successfully studied in a second sub-pilot research-scale unit, through a similar process called Syngas Chemical Looping (SCL). Both units are located in a building on Ohio State's Columbus campus, and each is contained in a 25-foot-high insulated metal cylinder that resembles a very tall home water heater tank.

A larger-scale pilot plant is under construction at the US Department of Energy's (DOE) National Carbon Capture Center in Wilsonville, AL. Set to begin operations in late 2013, that plant will produce 250 thermal kilowatts using syngas.

The DOE funded this research, and collaborating companies include Babcock & Wilcox Power Generation Group, Inc.; CONSOL Energy, Inc.; and Clear Skies Consulting, LLC.

http://www.greencarcongress.com/2013/02/osu-cdcl-20130211.htm


allvoices